Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by Yham

  1. Y

    Looking for source for FET SNJ132

    Hi, friend of mine is looking for FET SNJ 132. Any idea of manufacturer or where to get this part. It is descrete component used in gamma ray detectors. Thanks, Milosh
  2. Y

    Tektronix 2230 scope service manual

    Hi, I am looking for Tektronix 2230 scope service manual. Would appreciate any link to a free download. Milosh
  3. Y

    Protel DXP trace width

    Re: P*otel DXP trace width
  4. Y

    Protel DXP trace width

    Hi, Hope some of you guys still use Protel DXP 2004. Is there a way to change a trace width except to go to the Design/Rules... ? I am manually designing a board, and would like to be able to change it on the fly. Is it possible? Milosh
  5. Y

    Soft start for an AC motor

    Hi bafri, Thanks for fast response. Unfortuanately, I am not familiar with programming of any microcontroller. Anyway, I will go there and check what they have to offer. Milosh
  6. Y

    Soft start for an AC motor

    soft start ac motor I am looking for a soft starter for an 5HP AC motor. Any link to a schematic, sugestions... Milosh
  7. Y

    Converting from Express PCB to Protel DXP

    I am looking for an idea how to convert a pcb file that was made by Express PCB software (free software offered by manufacturing comp) to Protel DXP file. I am not familiar with Express PCB, and I doubt that there is an option of exporting to DXF or any other format. There is no problem if I...
  8. Y

    Exporting jpeg or gif from protel dxp2004

    Hello IanP, Thanks for replay. I will try to find a way how to export it into dxf. Thanks again. Yham Added after 31 minutes: I should have foud it before. Anyway, thatks again. Yham
  9. Y

    Exporting jpeg or gif from protel dxp2004

    Hello, I would like to send a schematic to a friend who doesn't have dxp2004. Does dxp2004 have an option of exporting an schematic in gif, jpeg of any other format than original format? Yham
  10. Y

    How to change a pad size on global level in dxp2004?

    Re: dxp2004 global change Hello sgilbert, thanks a lot for great explanation. Today, afternoon I'll try and let you know. Thanks again for shearing your knoledge. Yham
  11. Y

    How to change a pad size on global level in dxp2004?

    dxp2004 global change Hello, I am new in dxp2004, but have an experience with protel 99. I am wondering is there a command or something to change a pad size (not hole size) on global level, as it is possible in protel99. Thanks, Yham
See more

Part and Inventory Search

Back
Top