Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello everyone...
1) Facing a problem with A6 gsm module and don't know the solution.
When module receives new sms, it properly returns
+CIEV: "MESSAGE",1
+CMTI: "SM",0
Now if i use AT+CMGR=0 to read the sms, an error occurs +CME ERROR:58(don't know what it...
Hello,
I have flashed a new esp-01 client program using arduino software. The program is working fine but before this program, i was flashed accesspoint program in my esp. The name of ssid created was 'ESPap' and password 'thereisnospoon'.
If new program(client) is present in...
Thanx for your help.....
Yes!!!! Now At commands are working fine. I just used the 'terminal' software instead of 'accessport'/'putty'.
Here CR+LF settings are available easy.........Directly using arduino are also working........:clap::clap:
It's first time for me to use ESP-01 module. I am trying to test new module, using a serial monitor software 'AccessPort' / putty.
Coming to my point directly, when i reset the module by connecting RST pin to ground, i get following message
Here i was expected that getting ready...
Hurray!!!! Got the info about how to factory reset all setting of ATC1000(which will reset it's IP also):fight::fight:
Now Working all properly and accessing the 192.168.2.1 is done........ Thnx
First opened the unit atc1000, there is switch near power socket, pressed it on power on and...
Link LED is Blinking randomly...... ACT LED if OFF ..... and PWR i.e. Power Led is ON permanantly....
When i am trying to access 192.168.2.1, the browser time outs
Hello Fiends,
I am trying to access atc1000 ethernet to serial converter using ip 192.168.2.1(As given in act1000 datasheet) but not getting any response. Changes in PC setting has made to assign address in the 192.168.2.2 to 192.168.2.254 range with a subnet mask of...
I am back with the pulses.
Image 5) Object is 800mm from sensor- Module gives proper pulses-(OK).
Image 4) Object is 500mm from sensor- Pulse width decreases-(OK).
Image 3) Object is 350mm from sensor- Pulse width decreases-(OK).
Image 2) Object is 100mm from sensor- Pulse width changes...
Hello guys,
I am using this module jsn-sr04t, and getting the proper output upto 3 meters. Pulse width decreases when object come near to sensor.... Upto this is OK.
But the main problem associated with this is, proper output is from 300mm. If object coming more close to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
