Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hey,
I have a problem with CST.
I am simulating a coplanar resonator using CST software, see link:
https://obrazki.elektroda.pl/6857748900_1461403155.png
I want to increase the dielectric constant of the substrate from 100 to 10000.
So far I am not sure how I should mesh the structure, because...
Hey all,
I am performing a CST simulation of a coplanar resonator. When increasing the dielectric constant of the underlying substrate from 10 to 100 I get a warning at frequencies about 20 GHz, namely "at least one propagating mode is not considered at port 1".
What does this exactly mean...
Hey,
i have a gerneral question about CST microwave studio. Does it take the skin effect into account during the calculation or do i have to tell the programm to do that?
Best,
ychy123
Hey,
I am working with CST microwave studio since a few days. My goal is to perform a impedance transformation from 50 Ohm to 2 Ohm. Is there a possibility to measure the line impedance at a certain position?
Best regards,
ychy123
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
