Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have to design a 900Mhz meander line antenna(background is ground). I want to eliminate the ripple beside 900Mhz pole. I want to add a matching load at the end of the antenna(top) to eliminate the ripple.
Could to tell me what steps should I do?
Many thanks!
design of antenna
simulation...
I added a 50ohm resistor at the end of the meander line antenna in layout of ADS momentum and simulated it.
however, It did not work. The result was same as before(without a resistor), I checked it 3D view, the resister did not show in 3D view.
What is the problem?
Thank you!
I am designing a antenna and want to add a matched load 50ohm at the end of the antenna.
How can I add a load to the antenna in layout page. I could not find such button.
Can anyone show me?
Thank you!!!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
