Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Do you mean assertion and coverage checking?
Ya I told them that, But they want me to give some test vectors and check, which will provide maximum coverage i guess.
They asked me to develop a test plan to test the circuitry.
In that case can you help me with the test vectors that will provide...
I was asked "How to verify a 16 bit adder and a 256 bit counter."
I was asked how I will develop a test plan to effectively test the above circuits. They dont want the exhaustive testing of the circuit.
Please share your answers.
Many Thanks!
The MAX3232 converts the TTL to RS232 logic...I connect the 3 pins on the RS232 side of the converter(the Txd, Rxd,Gnd)
The other end of the converter, i.e USB end is connected to the PC.
Please let me know if this will produce the same output as the FTDI TTL to 232 cable.
I am not getting the...
Hi,
I wanted to know if the TTL to USB cable like the one in the link shown below can be replaced by a MAX3232 level converter circuit and a RS232 to USB cable.
The MAX3232 converts TTL to RS232 and then I have the RS232 to USB.
But i wanted to know if both cables transmit the same data at the...
Hey
I want to program the atmega324p controller.
But when i saw the "USBasp AVR USB ISP" programmer available in microstudio, it says that atmega324 is compatible with it but it doesn't say about the compatibility with atmega324p.
**broken link removed**
Whats the difference between...
thanks for the reply.
Plz let me know if i can program it using the USB to Serial Cable itself, as it was done in the AVR butterfly.
In that case i need not buy a programmer again.
Hi
I am new to the usage of microcontrollers.
So i have a doubt in what programmers can be used to download the compiled code from the PC into it.
I have a USB to serial cable. When i went through the manual of AVR butterfly it says that we can use this cable to program it.
Refer
**broken link...
Hi
I want to measure the AC current flowing through the mains wire of home electrical appliance like Tv, refrigerator.
I have shortlisted these 2 equipments for that purpose.
Kindly let me know which one is better?
Or if any other device is much more better than these kindly let me know
1)...
Hi
I want to interface a microcontroller and zigbee transceiver for home automation project.
When i browsed through atmel's website. I found the following models in which they are already interfaced and available in a chip format.
http://www.atmel.com/dyn/resources/prod_documents/8266S.pdf...
Thanks very much for the reply.
I ll go with AVR as you said.
Kindly send me any materials to this email: withloveshyam@gmail.com
(or) post it here in this forum itself.
Thanks once again.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.