Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi my friends.
I use ads to simulate a antenna,I set two ports,One port is Internal port,other is ground.The internal port real part is 14 Ohm and Imaginary part is 144 Ohm,Howerever smith plot show the normalization Z0 is 50Ohm,How am i debugged the antenna?How am i lookking S11 plot?
Hi to my friends
I am simulating a UHF RFID tag,layout is like:
///pet(0.5mm)
///metal(0.018mm)
///pet(4mm)
///metal(0.018)reflect layout
///pet(0.05)
Port setting:
P1:Internal port(14+j144)
P2:Ground ref(associate with p1)
S(1,1):
Fre:914Mhz
Imp:Z0*(1.013+j0.065)
Mag.(db):35.45
My question...
To Buenrostro:
I have tested your suggestion,but the result is error
your port`s define is right,but two port cannot define as photo,i do not know how to define the ports,can you tell me?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.