Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
Thanks for the quick replay.
Here D+ is the line and D- is the point where the load is connected.
Thanks,
Midhun V R
Hi,
Please see the attached image of Load connection to the neutral
Regards,
Midhun V R
Hi fiends,
I was working checking a circuit. In that circuit there is an AC DC converter section. The 12DC is generated from the neutral
line not the mains line. I was wondering how it works. This circuit is a part of a trailing edge dimmer circuit.
Please see the images attached. In the AC-DC...
Hi Friends,
We have a USB Dongle which is a MT7688 Processor based device. The device has a DDR2 SDRAM, W972GG6KB.
The device is going to hang state some time. To recover the device I need to repower it. There is no issue with 3.3V power
supply. Some times it occur in 1 or 2 days. But some...
Hi,
I am designing a BLE module using Texas Instruments CC2652P BLE chip. I want to add IPC balun on RF low power output
section and 20dBm high power output section of CC2652P. I got some documents for adding balun at low power output,
but no documents for adding balun at high power...
Hi
I am trying to make an SMPS using IRS2982SPBF ic. Input is 85-265Vac and output is 12V, 5A.
The datasheet only says the maximum switching frequency. It is 320kHz. It is not saying anything
about frequency selection. In some application notes they are using 40kHz and 65kHz. How can I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.