Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Can anybody tell me whether RTC(DS1302, DS1307) is compattible for ATTiny2313. Because from past three weeks i am working on it & i tried both the RTC. But till now i dint get any response from RTC. I have used I2C protocol to access RTC from SDA & SCL pin. SCL is generated by tiny2313 &...
interfacing ds1302 with attiny2313
Hi,
I am trying to set & get the time time for DS1302 interfaced with ATTINY2313. Can somebody post C code for this.
Thanks in Advance.:|
Added after 1 minutes:
Hi,
I am trying to set & get the time time for DS1302 interfaced with ATTINY2313. Can...
Hi friends, thanks a lot for replying to my post. My programm is working now. As said my chip has been fused at the first burning of my program. I was not sure about it but now cleared everything. :D
But if i remove External oscillator circuit , my program doesnt work at all. Again i tested by connecting external oscillator, my led started blinking. waiting for any reply.
Thanks a lot for ur reply friends...
I am using TOP Programmer 2007. A china made.
is it necerssary to burn the fuse?
But my LED Blink program worked with external oscillator 8MHz without burining fuse. I am totally confused.
vinstudy attiny2313
Hi all..
I am working on ATTiny2313. From past two days i am trying to send & receive data to tiny2313 through RS232. Program is very simple & I found it from net but not working. According to datasheet i have to burn the fuse, if i am using external oscillator. I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
