Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You need to have your specs with you....what frequency, whats is the desired bandwidth, gain, beam radiation etc.
Then of course proper indepth survey and finally realization
All the best!!
Dear Friends,
My question may see basic but ignore the level but choose to answer.
In order to design rectangular or circular shaped printed or microstrip antennas we have empirical formulae, using which we can design an antenna for a specific frequency and desired substrate.
If I wish to...
Hello!
I am facing a similar problem. If you have found a solution to it, please share it with me.
It will be of great help.
Thank you in advance for helping me.
Thanks All.
I took your advise and went thro the manual. I am now facing problems in analysis.
1. I have made a small 2D rectangle in the yz plane just below the inset feed, 50ohm line. I have now used this as the face for excitation as lumped port.
My air box doesnt touch the patch. it is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.