Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by Vinayram91

  1. V

    TRIAC Interface Circuit Help

    Hi, This circuit will works.but I am not sure that this is controllable.It will be controllable if you remove the R3 resistor and interchange the triac main terminals. ( Means replace MT1 with MT2 & replace MT2 to MT1).
  2. V

    [General] AC Supply Measurement

    Hi, In my board has both AC and DC Components.Both references connected with Diode.(Anode with Neutral and cathode with ground). I can power the board through both AC and DC Supply. I need to measure the AC load Current.Load can get close once triac gate triggered.that load current sensed by...
  3. V

    [SOLVED] Dimming LED bulb from main supply AC 220V

    YIM , Please find the image .From that you can dim the bulb.I had tested and done that successfullly.
  4. V

    [SOLVED] AC Dimmer Using TRIAC

    LED Bulb Dimming with Triac I had designed the dimming circuit with TRIAC.By changning conduction angle of triac using PWM signal,I can change the luminance of bulb.That means dimming.I have used the snubber circuit also to prevent the damage of the triac from the instant transcient of power...
See more

Part and Inventory Search

Back
Top