Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
how do i get the gbr file from eagle
I am using PIC24HJ128GP502 SPDIP package.
I do not want to solder chip itself, I want to use socket. I know it might be really stupid question but because this is my first PCB ever, so I have no idea.
Should I just select DIL28-3 in ic-package ??
pic18f eagle lib
How do I use DIP socket.
I need to use 28pin DIP socket for my PIC processor.
I see DIL28-3 in ic-package, is that what I use ??
I am very new to PCB design, this is my first time.
Thanks
dil28 eagle
I can find that.
is it same thing ?I want to use socket ?
I thought this is for ICs ( not socket). I really want to use DIP socket in my board so I can change ICs.
dil28
I am trying to make my first PCB layout using Eagle.
I need to use 28 pin IC in my circuit, so I am going to use 28-pic DIP socket.
But I am not able to find 28-DIP socket in eagle library, all I have Package: DIL28-3
No socket.
DIL28-3 and DIL28-3-socket are same ??
Because I can...
Re: Need help with schematic
Thanks for replies guys.
I think I am going to use PCB software to design my first PCB.
few questions based on ur replies.
1. what is the most common PCB software which is well known for small business, I can purchase something not very expansive.
2. What do you...
Need help with schematic
so if I use eagle, I will be able to send output file to manufacture ??
Or first I should contact them to ask what do they use ??
Need help with schematic
Hi guys
I am very new to PCB designing so please take it easy.
I am designing small circuit based on PIC microcontroller.
Currently, my circuit is working fine on breadboard, but I need to make it on PCB.
I want to know what software should I use to creat schematic...
Hi guys,
I need to use 0-200 Ohms pressure sensor in my project.
I am facing problem with linearity of circuit.
Can anyone suggest how can I get better linear response from my circuit.
Thanks
reading rpm of engine
Hi guys
I will give 20 Points if you provide circuit for this. :)
I need to read Engine speed (in RPM) using magneic pickup unit(MPU).
Here is the datasheet of sensor.
**broken link removed**
I am using 18F4580, I can do everything once I get signal inside PIC...
Hi guys
I need to convert a sine wave signal 0 - 3V into -9 to +9 sine wave.
I think I need to use Opamp but I am not able to figure out circuit.
How can I do it?
Hi guys,
I have one PCI I/O card from advantech.
But driver with card does not let me generate waveform as I want.
Now I am trying to access hardware directly from my program without any driver.
How can I do it ?
I know VC++ and VB.
Which one will be better to do this task?
Where shold I...
Yeah, U should try to explain you problem better.
Are you trying to interface Microcontroller with PC using Ethernet ??
Or you just want to write a code in C++ to Interface your program to Ethernet port ?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
