Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi everyone :)
So I'm planning to make an amplifier circuit, like shown in the picture attached.
Except I want to add an audio output, so I can e.g. record the signal that goes to the speaker. How should I go about this? Where should I mount the 6,3 mm jack?
Also, can somebody proofread this...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
