Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi KlausST,
Great suggestion but I cannot modify the PCB as it is locked and already scaled up. We kind of overlooked higher amperage loads and the noise is more pronounced at higher loads. We did put a DSP filter in the firmware to clean up the noise but then the response of the motion sensor...
Hi,
I hope everyone is staying safe and well in these tough times.
I have a PCB that is about 1" x 1" in size. It is a 4 layer board with a dedicated ground and power plane. I have 3 LED drivers that get pulsed at 5KHz and need to support up to 3A load on each channel at a time using a STM32...
Wow, that was super quick. Thank you so much. I think I confused with my post. I am looking for a pulse multiplier - lets say I get an input signal of frequency 10 msec, I want an output signal of frequency 20 msec - dividing the frequency by 2. I am not sure if I am searching it correctly, I...
Hi,
I am looking for an off the shelf frequency divider (need it divide by 2 only) that would take an input from a 24V DC and gives me equivalent 24V DC pulsed output with divided frequency
My real need is to get a pulse that triggers on alternate edges of another pulse with same voltage.
thank...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
