Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Is samone there who tryd this code because i am playing with rfm12bp modules and then dont lett me reed data from fifo if i first not read status registar and after then u can access to data in fifo, without reading status registar i didnt be able transmitt anything (what i think mesuring...
oke, antenna, and the entire assembly are well connected as they assembled on the test panel. My question is, how to check whether the signal SCK good, what should be a clock on the SCK pin and whether the clock should be constantly or only when communication between the MCU and module started...
hi, i have problem to make comunication betwin 2 rfm12bp modules, i wana make remote controller with them bt all samples and data i found on internet not help me:(. I am not so good in programing micors bt i programed in avr bascom. Rfm12bp have transmitt and recieve pins, i try to connect this...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
