Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
wow!
Thank you Kerim It's so obvious now. About the lower half of the sketch, I should have drawn the lower flat lines also as upward slopes - I was very rushed when I drew it. I understand why it would be this way now.
Thank you for all of your help.
---------- Post added at 15:49 ----------...
Hi again.
Designing circuits must be a nightmare!
I'm not sure what I can tell you about the circuit. It should be just a capacitor and a resistor in parallel. I just have a black box with a connector on either side.
A couple of people that have looked at this graph have both said 'yes, of...
Hi KerimF
Thank you for replying.
I probably haven't explained this very well. The square waveform is what I would expect if the circuit consisted of just a capacitor, the fact that the output is not this makes me think there is a resistor there too.
I don't expect it to be ideal in the sense...
Hi
I have a circuit containing a capacitor and probably also a resistor, but I am not sure of the configuration.
I have tried to measure the capacitance by passing a triangular waveform potential through the circuit. If it were just a capacitor I would expect to get a square waveform out...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.