Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
I am new to Matlab simulink, and try to start following the demo in the matlab folder. Here's the question
I simulate the demo.
1. Input: simple signal source (white noise, and sine wave), output FFT spectrum scope. Input source is frame-based, with "samples pre frame"...
Dear all,
I have questions about low-IF scheme. If I decide to have about 5MHz IF in the system, can you help to compare below?
1. Quadrature mixer+analog polyphase filter -> IF output -> ADC -> digital quadrature mixing
2. Quadrature mixer -> IF I/Q output -> ADC -> digital mixing
If the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
