Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What is the cost of K350QVG-V1-F module of the link **broken link removed** How can I interface the module (in hardware) with this kit from actel SmartFusion Evaluation Kit | Development Kits - Actel ?
I am searching for a lcd+touch module to interface with actel smartfusion eval kit SmartFusion Evaluation Kit | Development Kits - Actel Could anyone give me suggestions of low cost modules?
Hello everyone,
I have a "problem" concerning gain compression in TX top-level testbench considering overall system.
The TX budget is as below:
RF side -- external rf diplexer -- external PA -- external RF filter -- rf amp -- 2nd mixer -- external if filter -- 1st mixer -- if amp -- external...
sigma delta cic
Hi,
I have one question about the implementation of a CIC decimator filter. How I can meet my especifications of a output range of 16 bits in the CIC filter output? I have a 2nd order sigma-delta modulator that has a bit stream (1 bit output). Can anyone give me some...
Hi,
I had a problem with SMASH trying to simulate a transient analysis of a SPICE ASK modulator. The error message was:
ERROR: maximum number of consecutive skipped timepoints reached (aborting simulation). How can I solve this problem?
Thanks for your help,
Brito.
exponential vhdl
Hi,
I am trying to do a behavioral model for an OOK modulator who is a simple RLC parallel at an MOSFET N drain, which the MOSFET has a switched behavior controlled by a pulsed signal at gate.
When the pulse is on gate('1'), the current flows across the channel and the RLC is...
Hello!
I have a problem with SPICE simulation in SMASH version 4.9.
My operational system is a SLAMD64 Linux. The SMASH is OK, but when I try to simulate a SPICE transient, I have this problem:
ERROR: maximum number of consecutive skipped timepoint reached (aboting simulation)
Thanks for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.