Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
spectre parameter
I want to clarify my request.
I have HSPICE model parameters, provided by foundry. The file with extention "l" for example: model.l
But I need the SPICE parameters for Spectre, with extention "scs", for example: model.scs
So, I need to convert HSPICE parameters to Spectre...
convert spice to spectre
Thank you for reply.
I have HSPICE model parameters, provided by foundry. The file with extention "l" for example: model.l
But I need the SPICE parameters for Spectre, with extention "scs", for example: model.scs
So, I need to convert HSPICE parameters to Spectre...
ldo versus dc-dc switching
Linear regulators only step down and efficiency is equivalent to the output voltage divided by input voltage.
A switching regulator is a circuit that uses an inductor, a transformer, or a capacitor as an energy-stored element to transfer energy from input to output...
binary-weighted split-capacitive arrays
It's almost impossible to get 12-bit SAR ADC with good yield without callibration.
Split capacitor is necessary even for 8-bit SAR ADC.
Please check these topics.
It's impossible to get 16 bit SAR ADC without calibration.
And it's almost impossible to get even 12-bit SAR ADC w/o calibration.
You can check for ex. Analog Devices or MAXIM ADC spec:
AD7440 - 10 bit, AD7440A - 12 bit.
AD7621, MAX195 - 16 bit
Best regards
I've tried to mount my sub hdd with different options but w/o success.
When i plug in the usb hdd and then boot the PC, it detect the device and then stop and i can't boot the computer.
May be i need to do something with my kernel?
Hi,
I need Spice parameters for Al-N-Si Shottky diode.
Any parameters for real process is OK.
BTW, where can I find "BAT62_03W Si Shottky diode" spice parameters?
Best regards
Added after 6 minutes:
Dear b.pricope,
Thanks a lot.
It's very helpful for the begining.
Best regards,
uladz55
Re: contact and via size
It's not only metall stress problem.
If you have CONTs and VIAs with different size, you can get over-etching problem for CONTs and VIAs with smaller size and damage structure.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.