Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
What is the best way to make a sign wave shift frequency downward only about 10 Hertz, then repeat every .2 seconds.
The initial frequency 3000 Hz.
There will be 2 generators sweeping, both will be in sync (repeat at the same time).
See attachment for drawing.
On the microwave oven door itself, on the inside of the door around the perimeter there are a number of cavities. You must pop off a removable plastic cover inside the door to see them.
The cavities are formed from a bunch of bent tabs 3/4 inch wide, 3/4 inch deep, and are spaced every 3/8...
I am new here.
I am in need of a circuit to detect and warn me when 2 sheets of paper board (about 2 credit card thickness) and only 1 sheet is present.
I know a piezo transducer and receiver at 40 kHz is the correct frequency so I ordered the TCT40-16R/T piezo tranducer receiver pair.
The...
This is my first post here so I hope everything is ok. - I read the rules.
Do rf sign waves have a small attraction for each other when they are near the same frequency? I thought that electronics men might know why this happens. My experiment shows that they have some attraction for another...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
