Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You can measure after the diode on the input of the inductor, use 10 resistors 1R in parallel as a current sense and multiply the scope reading times 10.
That should work.
Tornado
protect avr eeprom voltage
Hi Ex4, in cellphones we use ESD diodes, they come in various clamp voltages,
check this link as a start.
https://www.vishay.com/diodes/protection-tvs-esd/
Tornado
Re: How to measure 0-30V with ADC that has 5V maximum input
Hi Giftbox, can you test the LM358 separate to see if is working properly?
It is probably blown by ESD or short circuit or the power polarity connected
reverse. Your circuit is correct. Another thing to keep in mind is that LM324 and...
Assembly or PicBasic, I am here to help. No problem my friend just give some details.
Input and output pins, button inputs etc.
We are all here to help you.
Tornado
Does you hex file has an hex extension?
Have you right click on the device and load that hex file?
Please post the hex file, so we can help you.
Tornado
use a pnp as switch
Just check this link with manufacturers spec:
**broken link removed**
They have circuit example how to drive a pnp+relay circuit with resistor
values and 2N4901.
Don't forget to use the diode across the relay coil and additional another
one across the pnp with cathode...
cypress y programmer
Here is another topic:
and also there is Psoc forum with lot of info and Psoc low cost programmers
http://www.psocdeveloper.com
Regards
Tornado
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.