Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
PCB fab small run - single sided - nothing fancy - down and dirty...
Can anyone suggest a PCB fab that can do this very inexpensively?
Thanking in advance.
I always felt it was necessary to place the gnd and pwr in the middle of the stackup.
For some reason an engineer said that isn't necessary now and he wanted them placed elsewhere.
Do users still do it the old way?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.