Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
For high speed operation they usually reverse bias the junction which decreases the junction capacitance, greatly improving speed, but the noise increases.
Running in p-voltaic mode into a low impedance load, gets the speed up but at expense of low sensitivity.
The device running into a low...
Unless you have a copy of orcad you cannot do anything with an orcad capture file as it is a binary file.
If you do have a copy , you could make a schematic of a memory array for your own tests.
You can get an eval version with limited capability from the Cadence website.
**broken link...
The very old SDT(?) version of capture did allow bitmaps for part symbols. This did allow import/export of ascii symbol files using asterixes to draw the symbols in a very crude way, as you might in an internet post to a forum like this. The current version uses vector graphics, so I don't...
This is a very late comment to this thread, but it may help others with the same issue.
This should work at least for ver 9.0 Layout.
You can just add the MAX file as if it were a LLB file from within the library manager.
You do this by opening library manager.
Then click add library...
Re: msp430 programmer
The original TI parallel port design discussed above was copied by Olimex with some slight changes. They make and sell the complete parrallel port unit for ~$16. Sparkfun is one of the distributors in USA. You could not build it yourself for $16. If you go to the olimex...
The Orcad router is actually a refined version of the 3rd party Masstec router. This was a well regarded oem router which could interface to about 20 different layout packages. This is still seen in that there are Pads and other layout package interfaces in Layout. Pads originally had a small...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.