Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
reply:
Hi, feynman,
Do you have the book? I mean e-book.
I found that "Rf microelectronic" from UCLA is better than Lee's "RF IC" because the former one gives you a lot reason. Another one I like is the book RF circuit design with matlab program(try to find @ mathworks.com)
I try to use AD8343 @
**broken link removed**
They just give the s-parameter and in the data sheet. the input impedance @50Mhz
is about 2.7 + 6.8i and output is 900 -77i.
I try to find the different input & output impedance @1.9 ~2.5 GHz, but I do not know how to do it? Would you please help...
Thanks a lot. Normally I always use protel several years ago to drow PCB in low frequency. I have never drawn PCB for RF. You know that RF is more different than low frequency. If I meet some problem, I will PM you. Thanks again.
Which software do you use in PCB layout when you design RF circuit? Is there any inofrmation about how to draw PCB board in RF design? Thanks in advnace.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
