Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi,
What can act like coax shield?
i meal if i have extra wire connected to the shield and i want to wrap it with some "tape" act like the shield....
Thanks, Jamshu
OK, I Cutted the dipoles from the split of the coax to the end of copper, still not that good...
I think the problem is the GND Wire, I mean its connected to the shield by 3-4cm wire.
You think this is the problem ?
And tell me if the connection of the wires is ok (From the picture I've posted...
BTW, The Shield connected this way:
Look at the "Blue Circle" I Draw there...
I mean I cut the gnd cable, and added the shield, and i twist all the copper's together...(start gnd wire, shield, the rest gnd wire).
Thanks, thedag
Something like, 30 meters in front the car,
7 meters behind the car..
Im feel like this antenna and the previous antenna is the same range,
Now the antenna i made is in the A-Pillar,
I Tried also on the mirror(for check) and actually out the car(for check also)
Still the same,
im also tried to...
i measured the the length from the point where the insulate starts, the center insulate, its incorrect ?
Where to measure the point from, i draw 4 points,please tell me from where, to where.
Thanks.
Damn, I've build this antenna, and im still not satisfied with the results....
i made it like this picture, with calculation to 325MHz :
BTW, The legs of the dipole are something like 1.5mm i think...
maybe its too big?
Please Help....
the antenna is on one of the pins,
can i just keep something like 10cm of the old antenna, and solder to it the center of the Coax cable ?
and how can i solder the braid to the ground pin?
Please tell me if you have MSN Address or Skype, its can be much faster, please.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
