Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i am trying to design a microcontroller based fault detection system where a single receiver will receive any data from multiple transmitters. it is assumed that at a time only one transmitter will send the data. all microcontrollers belong to 8051 family, and have a 11.059MHz crystal. the baud...
i need to generate 3 pwm simultaneously. i am using 18f4550. 2 ccp channel is there.for the third pwm i am using timer0 in16 bit mode. but i can not generate pwm with proper duty cycle. i am writing the code in ccs c. can i get some help?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
