Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
File -> Export -> STEP 3D -> Export Options and
OutputJob -> Configuration -> Export Options
has different export options tables and gives different result. I can not get pad holes exported in OutputJob.
See attached picture:
Found the problem! Uninstalled last windows10 update (4284835) https://support.microsoft.com/en-us/help/4284835/windows-10-update-kb4284835
And PDF exporter works as it has to:
Yes, I can select/deselect, but result is the same. Some text names are exported and some are missing. I get the same result if i do a print on paper directly from schematic.
It was working properly some days ago, my guess is, if some Windows10 update might influenced this???
Has anyone faced a problem while printing schematic to pdf file a lot of text strings disappears, i.e. power port labels, pin and net label strings ect..
Some of them not printed to pdf, while in schematic file they do exist.
Hi,
I need to design an Ethernet Surge Protector. I have fond one simple and cheep circuit solution on the web:
https://tyconpower.com/products/files/TP-ESP-100-POE_Surge_Protector_Spec_Sheet.pdf
Can anyone advise how to select varistor Z1 and Z2? Why they are different?
Some diodes i.e. D1...
Check this link:
Fill the required windows with your parameters and press "Transformer Data" button. You will get several transformer core options for your design.
- tantudaisu -
I need a suggestions, how to realize PoE passthrough circuit.
There are two JR-45 connectors in my PCB. First is data+powerIN, secont data+powerOUT.
Do I need to use both PD (powered device) and PSE (power source equipment) ICs in same circuit? Or there are any other solutions?
- tantudaisu -
If output depends only on transformer turns ratio, it means there are no feedback regulations in your simulation circuit.
Primary wiring current ramps up until reaches comparator's (current sense) threshold causing mosfet transistor to turn off. Then voltage on the secondary wiring goes as...
Well I think he called unrouted messy nets as "rat's nest" :)
That senior engineer is a rely an old sea wolf. To do new layout with Protel is the same as to write a book with a typewriters or better with a pen, like medieval monk...
- tantudaisu -
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
