Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
type v e&m
HELLO ALL
I need information (or where to find-it) about the hardware needs for a E&M type V voice interface. Also I need same about the QSIG o CAS signaling.
Thanks
Hi all
I need to include in a design two ethernet ports. The object is do not to occupy any ethernet port used for other. I think this like a little hub.
I need ideas for how to do this.
Thanks
Thanks to alls
I solved this problem. In the Layout´s spreadsheet, I must to active the nets options and to select GND and VCC. Then I can select which plane I want for such net.
I try to make a 4 layers pcb. I assigned VCC and GND in the spreadsheet to inner1 and inner2 layers, and I signed the PLANE option in this.
When It starts route, as with SPECCTRA_ as with internal autorouter, It appairs these nets all traced but not use internal layers.
Whats is wrong? How I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.