POWERPLANES WITH _LAYOUT_

[TANTALO]

I try to make a 4 layers pcb. I assigned VCC and GND in the spreadsheet to inner1 and inner2 layers, and I signed the PLANE option in this.
When It starts route, as with SPECCTRA_ as with internal autorouter, It appairs these nets all traced but not use internal layers.

Whats is wrong? How I must to define internal powerplanes.

Thanks

 

[AG]

Possible you have 2layer routing specctra or an error to configure layer.

 

[sigint]

What software are you using?

SiGiNT

 

[concat]

Dear

In Specctra autorouter, It don't define a plane layers, so when use specctra, please don't create plane data, after run autoroute and translate to Software, which U use to route, run plane data, everything ok.

Best Regards

Concat

 

[TANTALO]

Thanks to alls
I solved this problem. In the Layout´s spreadsheet, I must to active the nets options and to select GND and VCC. Then I can select which plane I want for such net.