Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Re: question on HFSS example:Ultra-High Frequency (UHF) Prob
hello
i had te same problem
but when i used the hfss v11 ,i didnt get these warnung
so please use hfss v10 with bokk hfss10
and hfss11 with book hfss11
for more help tell me
when you draw a conductor in the 3D simulator then through the adjusting of the boundary conditions you can determine whether this conductor behaves like a T.L(here S12=0dB in case of two ports contected to the terminal of the conductors)or like an radiator atntenna(if you put the boundaries...
hello,i want to layout a inductor and capacitor ,the capacitor musst withstand high power.
see please the attached photos
who can layout the capacitor and the conductor(the values of the capacitor and inductor are just example)) in momentum with the given value.at 300MHz frequency.
thank you...
hi
i want to know how to use the
1-smith chart utility
2-impedance matching utility
in ADS
to design a impedance transformer using single stub??
thank you
hi
i want to know how i change the unit of components like length from micrometer to milimeter in schematic,i mean not one by oneand after i built the circuit?
thank you
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
