Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by SynKore Support

  1. S

    Qua/STAR flourescent lamp

    Try to design a new circuit, using some these components to drive white light LEDs? White light LED will be ideal lighting source of next generation, I think... Michal Zhang
  2. S

    Problem with Avnet Virtex-II Pro Eval Board

    Hi, Fenrir, Have you solved the problem? I have an idea and you can have a try. You can bypass the FPGA (maybe you need to open a trace on the board), chain only the PROM's JTAG pins with your cable, programming the PROM via your cable, then config the FPGA using master serial mode. I hope...
  3. S

    the way to generate register

    This is the version in verilog, FYI: reg Q; always @ ( negedge Rst_n or posedge Clk ) begin if( !Rst_n ) Q <= 1'b0; else if( En ) Q <= D_In; end Michael Zhang ============================== Your Ideal Prototyping PCB service: **broken link removed**...
  4. S

    gps logger .... which type of memeory should be used..

    Yes, dani, why not try to solve the I2C problem? Check the pull-up resistors, I2C timing, START/STOP conditions, etc... Michael Zhang ============================== Your Ideal Prototyping PCB service: **broken link removed** ==============================
  5. S

    Reading PIC Data via COM

    Hi, kasamiko, Portmon is an useful tool which will help you to monitor the data flowing through com ports. **broken link removed** Good Luck. Michael Zhang ============================== Your Ideal Prototyping PCB service: **broken link removed** ==============================
  6. S

    Where to find Nan-Ya LCD datasheet?

    Re: LCD Datasheet Nan Ya is a Taiwan LCD factory. Here is their website: https://www.mark-products.com/ https://www.mark-products.com/factory.htm You may find part number information here: https://www.mark-products.com/part.htm Good Luck! Michael Zhang ============================== Your...
  7. S

    What skills are needed for high speed board designer?

    Re: High speed board design Knowledge on PCB manufacturing is necessary, I think. You should have good understanding on impedance controlling, copper thickness, stacking up, etc. Michael Zhang ============================= Your Ideal Prototyping PCB service: **broken link removed**...
See more

Part and Inventory Search

Back
Top