Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am a beginner in AVR programming.Can someone please tell me the steps to transfer my code from PC to AVR development board.I am using AVR studio and CVAVR compiler.
Where is SPROG3 target ISP header in AVR DEVELOPMENT BOARD ver.3?
I am doing a small project on AVR development board ver.3 .And I have to connect ISP6PIN header to SPROG3 target ISP header with the 6-wire cable.But i am not able to locate the SPROG3 in this kit.
I mean if I have a signal which is a combination of two real signals in which one signal is 90 degree phase shifted with respect to another signal.And i want to give them to two different input terminals,then how to give that 90 deg phase shifted signal in orcad schematic?
I know how to do this...
I am designing a circuit in Orcad schematic.I am using a complex input vc=v1+jv2...where v1 is real part and v2 is imaginary part.Now i want to give v1 and v2 at two input terminals.So,how to do that i.e since v2 is 90 deg phase shifted w.r.t v1. So,how to introduce that 90 deg phase shift?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.