Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by swapna.b

  1. S

    Connecting DDR with 2 series ressitors

    Hi, Your question is not clear to understand. could you explain clearly.The series should place only on Address and control signals only.
  2. S

    How much more expensive is MCPCB than 0.8mm double sided FR4 PCB?

    Actually the cost is double if compare to double side FR4.But MCPCB is a good choise to select for power LED's.It will dissipate heat properly and LED life will also improve. Thank You, Regards Swapna.B
  3. S

    How much more expensive is MCPCB than 0.8mm double sided FR4 PCB?

    Hi, MCPCB is quite costly.But it is good to choose dissipate heat. How many power LED, you are using in your design. Regards Swapna.B
  4. S

    Recommend topology and control circuit for switching power supply 0-200W

    Hi, Forward topology is the best solution for this high power output requirement.Power MOSFET will also available (reasonable prices) which meets all your specifications. Thank You, Regards Swapna.B
  5. S

    LED flickering problem

    Probobly Your circuit driving current is not suffient.It may have a chance to flicking the LED's
See more

Part and Inventory Search

Back
Top