Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
As per the attached picture, I've built Fig 10-2 on P21 of **broken link removed**, and I can't seem to make it work. I've presently joined the 10K resistor and the yellow wire that leads to MCLR with alligator cable (not shown) together (to complete the circuit). Every time I try to program my...
What would happen if I used a capacitor that's greater then 10 nF and what would you size for a resistor? So far I'm thinking a circuit like this: http://www.labbookpages.co.uk/electronics/files/debounce/debounceCircuit2.png.
I used a 80 Ohm resistor as I was using a very small 3 mm LED. Do I have to use a current limiting resistor on the NAND Gate's Vdd pin?
And your right, I left the other inputs of the NAND gate open. But why does the other inputs effect the inputs that I was using? One good way to explain this...
After trying to build my first NAND gate SR Flip Flop circuit using a **broken link removed** chip, I came in to weird problems last night. I basically had a small LED placed on Q' to show me if that side of the circuit worked or not, however, my problems were a bit weird. What I noticed would...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.