Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Actually this heater had been tested to heat up to 300 degree celsius using a previous clip, but the previous clip had been changed to a new clip shown in above picture. The clip had been changed due to the connection sensitivity where the clip could not sense the heater and causing open...
Look! I had a platinum heater which look small in size like a chip, the size of it is 15mm x 13 mm, thickness not more than 1 micro meter, the temperature range is more than 300 degree celsius.. does any one know how to connect the heater with wire to make a close system!
Note. Using clip...
Look! I had a platinum heater which look small in size like a chip, the size of it is 15mm x 13 mm, thickness not more than 1 micro meter, the temperature range is more than 300 degree celsius.. does any one know how to connect the heater with wire to make a close system!
Note. Using clip to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.