Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am facing difficulty during report generation in ansys. While generating report, plotting frequency vs return loss, I get different result for different scaling. That is, my design frequency is 2 GHz. When I plot graph from the range (1-10 GHz) and (1-3 GHz), I get different results. For the...
Yes I can use the same feed. But since I am designing it for mobiles, I am not sure what dimension is to be applied to such a feed and mainly the disc load mentioned in that paper.
I want to design a transparent antenna for mobiles. so I am using water patch. i referred the following paper. https://ieeexplore.ieee.org/document/7987716/
can i use coaxial feed instead?
I am using water as patch which is enclosed by plexiglass. what type of feed should I use to excite it?
If I use coax feed, can i make contact of the coax pin with water?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.