Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
plz help me do project......
in my project using a RTC Ds1307 .But have doubt, plz help meeeee
1) Firstly we entering current calender?
2) IF yes hows that do?
thanks in advance .......................
Re: communications 1
using SSB but using voice this methode is gud .Incase of video this not gud VSB is gud
---------- Post added at 08:45 ---------- Previous post was at 08:41 ----------
**broken link removed**
---------- Post added at 08:46 ---------- Previous post was at 08:45 ----------...
this device N-CHANNEL 60V - 0.08 ohm - 16A TO-220/TO-220FP STripFET¢â II POWER MOSFET - STMicroelectronics
if u want datasheet plz goto this link
STP60NF06FP datasheet pdf datenblatt - STMicroelectronics - N-CHANNEL 60V - 0.08 ohm - 16A TO-220/TO-220FP STripFET¢â II POWER MOSFET ::: ALLDATASHEET :::
if that symbol represents propagation delay(Ist ckt 1x,1x and IInd ckt 1x,2.5x) the first ciccuit is more fast
---------- Post added at 06:54 ---------- Previous post was at 06:51 ----------
plz goto this link..........
Digital Integrated Circuit Design From VLSI Architectures to CMOS...
the regulator is two type one is resistance type and other is electronic(using scr). But we use resistance type the speed is changed also the fan using power is change ,but the regulator drop the power .so total power always constant in case of resistence type. we using scr type we can save energy
thank you...................................
but this function have't UART1_Write_Text("Start");
and why use these two lines
UART1_Write(10);
UART1_Write(13);
pic 16f877 interface through USART in MICROC and proteus.but have problems that is below plz help meee...
void main() {
// Initialize USART module (8 bit, 2400 baud rate, no parity bit..)
Usart_Init(2400);
do {
if (Usart_Data_Ready()) { // If data is received
// Read...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
