Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,I need an help to find an utility for calculating an N order polynomial starting from a well defined number of points.
Thanks in advance,best regards.
Stark
www.linear.com/pdf/an43.pdf
You can find good solutions using pSoc micro from Cypressmicro,
check around application notes on Cypressmicro website
bye Stark
Re: filters on PIC 18
Be patient,very soon they will be available DsPic from microchip.
they have an extensive capability on dsp algorithm calculation,maintaining optimal microcontroller characteristics and a good approach.
You must wait two months at least
bye Stark
It depends on operating frequency you can always think to write VHDL model to fit your apps in FPGA because DDS usually generates sine and square wave function.
Stark
BIT-SLICE Microprocessor Design by Mick and Brick published by McGraw
Hill , ISBN 0-07-041781
This the best book on bit-slice technique of computer implementation I've read
It is based on Am29xx series of devices although there is another newer series
Am29xxx
convert 220 110 2 capacitors
Hi if you want to reduce the voltage you can modulate a 220VAC rectified voltage with a sampled sinewave in a pwm mode such as in motor drive in direct sinusoidal control;you need only one micro with pwm module and for igbt with drivers (high/low side)
Stark
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
