Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Recent content by stachuc

  1. S

    [General] PICPgm lvisp programmer recognized as Tait

    Thanks wp, Now I'm traveling and will be back home after Christmas, then I will continue. I was trying to investigate a little bit those config parameters but was not able to find much, not much time for it as well. But what I can see right now is that you have LVP=OFF and that will not work...
  2. S

    [General] PICPgm lvisp programmer recognized as Tait

    This is how my programmer looks like at the moment. PICPgm recognize the programmer in auto-mode and PIC chip as well, no problems After pressing "Program PIC" I got a message "programming successful" and PIC can be verified without any problems. But not sure if the PIC is doing what expected...
  3. S

    [General] PICPgm lvisp programmer recognized as Tait

    Thanks for posting. Can you recommend any manual about those configuration bits? Looks like for each PIC and each compiler the way of defining them is different. I'm trying to do it with MPLAB IDE it looks like in the program it should start with "__config" but what comes after it is confusing ...
  4. S

    [General] PICPgm lvisp programmer recognized as Tait

    Thanks wp100, You probably right, but the thing is I want to understand how it work, from the beginning. Maybe that stupid but ... Anyway, there is some progress with my programmer. So I confirm that as long as the circuit is correct the PICPgm will recognize the programmer. But the programmer...
  5. S

    [General] PICPgm lvisp programmer recognized as Tait

    I don't know why but it just started to recognize it correctly, except PIC, but at least the programmer is now recognized by PICPgm just fine. I did play with the "Pin Configuration" in Hardware/Hardware Selection/Configuration... First MCLR, Clock and Data Out were marked as "Invert" i have...
  6. S

    [General] PICPgm lvisp programmer recognized as Tait

    Hi All Just started my adventure with micro-controllers. I have build a LVISP programmer as described here: http://picpgm.picprojects.net/hardware.html#LVP_PROGRAMMER but when I autodetect in PICPgm it says it is a Tait Classic PIC Programmer. And the PIC device is not detected. I enabled...
See more

Part and Inventory Search

Back
Top