Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
George, Thanx. But, transistor will invert the signal or it will shift the signal?
I already have 2 MOSFET as a switch for my circuit. What if i don like to use transistor for phase delay?? Any possibilities to generate through software?
Dear All,
From the old threads I found it is possible to use 2 PWMs simultaneously using CCPCON1 and CON2. I'm a beginner in PIC programming.
I want to generate the PWM pulses for same frequency and same duty cycle with 180 degree phase shift delay. Can someone assist and provide me with a...
Dear All,
I have been reading interleaved boost converter related paper for couple of months now. I understand the concept of the converter. But, I couldn't find any useful formulas to design L&C values. Again, some claims the formulas are same as that of boost converter.. Here I need two...
Re: Confusion in Simulation Parameters
Hi,
Thanks for ur response. But u know i have completed the theoretical calculation. I have parameters too. I'm newbie for IE3D. I dunno how to apply values in synthesis.
Please help me..
Hi,
I have lot of confusions in applying parameters for the simulation of Low pass filter.
The details of parameters are as follows:
fc=1GHz, Passband ripple= 0.1dB, Zo=50, dielectric constant =10.8, lenght of c = 7.11, lenght of l=9.81, width of c=4 and width of L=0.2.
Whether the values...
Dear Mr. Manju,
Thanx for your response. I'm new to the field of RF and Microwave engineering. Shall i have your mail id so that i can contact you sometimes personally if i need any help in this regard.
Regards,
Sheik Md.S
How can i convert the impedance values of lumped elements into dimensions (length and width). Can anyone help me?
Anyone have materials or book for stepped impedance low pass filter design..
Hi to All,
I wanna design the low pass filter which should be placed after the receiving antenna using IE3D. Can someone help me in this regard. Anyone have the manual or step by step procedure to design such filter. Also pls write to me that how i can connect the filter with the existing...
Re: Freespace wavlength
Dear Shameer..
Thanks for your reply. I don't have enough resources (books) in my university as it is young one.
Can book fine the e-book for the mentioned book?. Can u send any material to me if u have the soft copy for the design.
Regards,
Sheik Mohammed
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.