Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
175 mm approx
---------- Post added at 16:42 ---------- Previous post was at 16:38 ----------
the sensor will be placed 175mm approx above the ground height and at an angle of approx 30 degree.
I am sorry for the fact that my model is not much of an assistance, but the gist is pretty much so. A blind person holding on to the cane will be guided through busy areas, and roads. The best position for this sensor would be at the top of the cylindrical body. So from there having an angle to...
Good Morning to all, I am working on a Robotic Guiding System for the blind, where i need to determine pot holes on the road, from a min distance of 1m. so any sensor i use will need to be aligned at a certain angle from the body of the system. So any IR or proximity, or ultrasonic wont be...
laser works on the principal of light..the transmitted laser should come back to the detector. simple principal..why the need of a binocular? if you have a long range of distance to measure try an ultrasonic module, gives you approx range of 5m at 70 degree.
I am using a CPLD board using Xilinx XC9572.i have a parallel port programmer for it, but since i do not have a parallel port in my laptop, i could not programme it using my laptop. A usb programmer for my board will be most helpful. The programming ports in my board is in the following order...
Where can i find ICL 8038 for simulation in multisim? or any alternative which produces the same result as ICL 8038? i ned to produce a FM wave using ICL 8038.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
