Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
capture error calling vid_start
i am using linux ubuntu 7.10. I have installed my motion software i've downloaded from https://www.lavrsen.dk/twiki/bin/view/Motion/WebHome. but now i cannot see any output grabbed from my analogue camera (using RCA connector) that i connect to my capture card...
I cannot connect o internet at all whenever i switch to linux environment.. Seems like may network card interface cannot be detected.. see the pic below..
Hi shiv_emf... I already check my package library, i only have libjpeg62.. And i also need jpeg62.dev.. But in my package not included. U have any idea where to get it? I am a beginner...
ann@anndesktop:~$
sudo aptitude install libjpegdev
Password:
Reading package lists... Done
Building...
epson31411eu download
I get error while install the downloaded source..
The ouput is as below:-
ann@anndesktop:~$
cd /home/ann/desktop/
ann@anndesktop:~/
desktop$ ls
bttv0.9.15
epson31411eu.zip motion3.2.9.
tar.gz
bttv0.9.15.
tar.tar epson31411eu.zip_FILES
ann@anndesktop:~/
desktop$ tar xvzf...
hi shiv_emf. I already use that command but than still, fail. The output is as below.
ann@anndesktop:~$
tar xvf
/home/ann/desktop/bttv0.9.15.
tar.tar
bttv0.9.15/
bttv0.9.15/
v4l1compat.
c
bttv0.9.15/
v4l2common.
c
bttv0.9.15/
videobuf.
c
bttv0.9.15/
videobuf.
h
bttv0.9.15/
videodev.h...
i cannot connect my computer to internet whenever i switch to linux environment. My cpu got 2 operating system. When i switch to Windows i can connects to internet but when i switch to linux, it can't. I already try to configure the setting on my own and post some question on forums but still...
I got problem install tar.tar file in linux ubuntu. The file name is bttv-0.9.15 tar.tar. The downloaded source do not have configure file and make and make install file. Anyone can help me? Help me!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.