Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Is the input of a charge amplifier supposed to be high impedance ?
please check the online reference http://people.na.infn.it/~barbarin/Biblioteca%20rivelatori%20ed%20elettronica%20(per%20studenti)/rivelatori/hamamatsu/Characteristics_and_use_of_Charge_Amplifiers.pdf
Now my confusion is that...
Thanks FvM, your suggestion makes a lot of sense. But how am I going to get a current output from the filter since the next stage of the filter is a charge amplifier ?
charge amplifier project
Hi all,
I am trying to design a three pole low pass RLC Butterworth filter for a piezoelectric transducer, the piezoelectric transducer's output is charge instead of voltage. The piezoelectric transducer can be modeled as a voltage source in series with a capacitor...
Read Razavi and Paul Gray books, do problems after each
chapter, compare your answer with the solution and try to
figure out what is the advantages of the solution design over yours.
You will get a good feeling about analog circuit design by doing so.
Added after 2 minutes:
As for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
