Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Currently, I am designing a Waveguide adaptor that required to use of the 1.85 mm connector at the end launch.
In the simulation, I need to design the coax which has exactly the same dimension as the 1.85 mm to ensure a small discrepancy after fabrication.
From the simulation, the result...
You're right Sir.
The center frequency of the PCB is 1.5 GHz and the pad attached to SMA connector.
It is not a single pogo pin, it is 4 ports network. We want to see the crosstalk also.
Kindly see the attached new image configuration and S-parameter.
I hope you can point/provide an idea about...
Hi all respective member!
I am working with PCB routing to POGO pin, but after I place PCB over pogo's pin the result is lossy and even has some spike at center frequency due to impedance mismatch.
So is there a tool or technote that tells about the via hole diameter with copper plated thickness...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.