Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi All,
We have a requirement which suggests to use an input signal with 5dBm+/-2dB @50Ω.
I am confused as the tolerance unit is in bB while the actual value is in dBm.
How do I convert it to its voltage equivalent?
Thanks & Regards,
Naveen
Hi All,
In our design, we have an ADC which gives out differential parallel outputs.The ADC operates at 3.3V. The differential output is interfaced to FPGA, which operates at 2.5V.
Is it necessary that both transmitter and receiver should be at the same voltage levels?
Thanks & Regards,
Naveen
Hi All,
We are planning to use a BT module to an existing design. We are providing speaker out of the BT module to an audio codec, which has analog input channels. We are supposed to convert the differential speaker out of the BT module to single ended and feed it to audio codec.
Please...
Hi All,
Why does a pin of an IC have a capacitance associated with it?
What is its importance?
I have not been able to get a clear picture of it. Please help.
Naveen
HI All,
What is Bus capacitance?
In I2C, what are the advantages and disadvantages of bus capacitance?
Also, suggest some links or documents related to this.
Thanks,
Naveen
Hi All,
What are the causes of the ripple in the power supply? Are there any other reasons apart from the inherent ripple present in the main power supply, to cause ripple in the power supply?
Regards,
Naveen
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.