Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi all,
I have read this statement in the manual of an Input module card.
" Cross talk of input circuits by walk zero test."
Can anyone please explain me the meaning of this.
What is walk zero test?
Hi all,
I want to learn the GEs Mark V control system. In this regard, i searched for the manuals on mark V control system but the manuals do not explain this system in detail or in other words they are not relevant to what i want. Can anyone please share a presentation on GE Mark - 5 control...
Hi all,
I am using xilinx SPARTAN 3 PCI Express starter Kit and want to communicate with FPGA through PCI Express communication. On PC side, i will be using Visual C or Labwindows software for sending some data packets to FPGA.
Can anyone provide some manuals or application note on this?
Any...
Hi all,
I am using Xilinx SPARTAN-3 PCI Express Kit for the first time. I have studied the manual of this kit and want to program the FPGA by using Xilinx Platform Cable USB II, model is DLC10.
I would like to give the following information
1) The FPGA Configuration ( JP3 ) is set to...
But , when i previously checked the output voltage of ups , it was around 220 volt on load. There must be some problem with the output voltage of UPS now, because each time when the ups comes on load , the FUSE blows.
Regards
Hi all
The output voltage of my UPS is approx 300 volts. I have also checked the transistors, they are working properly. When the battery is charging , through main supply, the output voltage is upto the normal value that is 220 volts, but as soon as the main supply fails and the UPS starts ...
Hi all
Can anyone tell me, how many types of DC motor starters are there? Please send me any document on this which contains all the types of DC motor starters with their electrical diagrams and working.
Any help will be greatly appreciated.
Regards,
mhs
Hi all
I have a question to ask? Suppose if you have 3 step down transformers from 440V to 220V then how we can connect these 3 transformers such that at any of the two terminals out of the Six at the output, a 220 Volt bulb must glow. Please solve this.
Any help will be greatly appreciated...
Hi all,
Its a common observation that the input supply of 3-phase motors are indicated
by the symbols R,S and T. Does anyone of you know what R,S and T means?
Any help will be greatly appreciated. :-)
Regards,
simon
Hi every1
Can someone please send me the code in C++ for PID control? The code should be like that when it is run , the window should ask for Kp, Ki , Kd and sample time? and then generates the pwm output. I will use a USB daq card for to control the motor speed.
Any help will be greatly...
Hi all
Did anyone use the Microchip's Framework v1.0 of USB for PIC microcontrollers?
I am unable to understand the code of the framework. Please can anyone send me the flow chart of the framework?
I have also studied the User guide of the MCHPFSUSB framework but i didn't find any flowchart in...
Problem with Layout Plus
Hi all
I use Orcad version 9.2. I have been using this software for the last 8 months,It is installed in my PC. Capture CIS , Layout Plus and Pspice are working well but from the last few days , when i go to start menu and click LAYOUT PLUS , nothing happens. Its...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
