Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
but in my project ... the pins 14 and 15 did not issue pulse ... just being in the point 0 .. according to you ,,over-current,, over voltage or other reasons?
I want to make a circuit of analog PID with settings of P, I and D using the selector switch that set the stage resistor from the strengthening of 1 to 10, .. how the circuit?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.