Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Consider the effect of clock jitter on the sampling of the input signal. A sinusoidal time jitter with amplitude a and frequency w will cause a sampling of the input signal at time t to instead occur at time t+asinwt. The effect is the same as if the input signal Acoswot were instead Acos[wo...
implementing fft in matlab
Syntax
Y = fft(X)
Y = fft(X,n)
Y = fft(X,[],dim)
Y = fft(X,n,dim)
i think, it will be very useful if u see matlab help or visit mathworks.com
cic spectre pdf
use delsig toolbox to calculate SNR using function "simulateSNR" and similarly u can simulate ur delta sigma converter using function "simulateDSM" .use other function similarly. before going to use just read the help of toolbox.
Re: PC parallel port
use some octal buffer ICs to make eight bit input into two four bit input and then ur 4pin status input can acquire one bye one.it will solve ur problem for eight bit data input.
if u will use power MOSFET to drive ur stepper motor, then no need to worry about current consumptions and torque. try it. IRF 540. see data sheets also.
Re: Fuzzy book..???
I think it will be helpful to u
Introduction to Neuro-Fuzzy Systems
Series: Advances in Soft Computing , Vol. 2
Fuller, Robert
2000, XII, 289 pp. 185 figs., 11 tabs., Softcover
ISBN: 978-3-7908-1256-5
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
