Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hello
Who can explain to me how this full wave rectifier works ? i can't really see
my guess Idc current proportional to oscillation amplitude, so is V+, is that the principle or something else
thanks
hello
can you help me calculate the gain of the cmfb
here is the schematic
and the author gives the following gain:
i understand the 2gm6/(1+gm6R5), thats the current which is mirrored up to node B, then from node B on i am lost, how the current at node B is converted into a voltage...
hello
i need tio measure the PSD of a differential DUT
so my guess is that i let the inputs open, connect the outputs to a balun and analyse the spectre with a spectrum analyzer to get PSD versus frequency
is that correct ?
should the inputs terminated with 50 ohm ? in that case i will have...
hello all
i did an oscillator but there is a discrepancy between stb analysis and tran analysis
the 0° cross frequency is about 300Mhz higher than the oscillation frequency
what could be the cause ? can i quantify the cause of this discrepancy
many thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.