Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
hey I am able to configure two xbee modules using X-CTU terminal and both of them have successfully established a link..But I want to send a text file from one xbee module to other using X-CTU terminal..There is option of opening and sending file in X-CTU--(Click on terminal tab, then on Xmodem...
Thanks for your reply,
can u also tell me how to set pulse width in arduino coding coz I am actually new to arduino...I did it in this way
for(pos=1000;pos<2000;pos+=1)
{
myservo.writeMicroseconds(pos);
delay(20);
}...
hi..
I am trying to rotate my servo motor wirelessly through RF module using Arduino UNO at transmitter side and on receiver side i have my servo motor attached. I want to know how to successfully transmit PWM signal because I am not able to transmit by signal till motor which can cause it to...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.