Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi there,
This is my real hardware circcuit shown in below
in which used component like MOC3021 (OPTOCOUPLER), BT-136(TRIAC),4 SWITCH(BUTTON),CRYSTAL 20 MHZ,PIC16F72(MICROCONTROLLER),
7805 and 16X2 LCD .
project details-
pin conncted to pic16f72 MCU as
sbit LCD_RS at RB2_bit;
sbit LCD_EN at...
hello sir,
you said in above thread .
Now if you want to simply display 0-5 volt on LCD using UP/DOWN switches, it could be easily done..
please tell me how.
hi sir,
i sent real hardware circuit shown below in which all component are attached .
like BT136,MOC3021,SWITCH,20MHZ CRYSTAL,7805 REGULATOR,and all types of resistor included.
then i want to dislay votage range(0 to 5) changing voltage with switcyh(up)and switch(down).
please help me
hello sir my laptop was damage so i could not able to reply.
but that time my laptop is woking...
adjactly
i want to display 00to 5v and time on lcd. i am using pic16f72 mcu ,triac and optocoupler.
i want to change voltage value 00 t0 5v with swith (puss button)...
i attached simulation like this
hi there,
some day ago my project be completed beccause your helped and sporrted ,
my new project is same as previous but diffrent things is only in which use BT136 and MOC3021.
i dont know how to voltage read , regulate and display on lcd . i am searching about this term almosl 1 months read...
hi there,
some day ago my project be completed beccause your helped and sporrted ,
my new project is same as previous but diffrent things is only in which use BT136 and MOC3021.
i dont know how to voltage read , regulate and display on lcd . i am searching about this term almosl 1 months read...
Yes swapan......it's now flashing the controller and works according to software after untick the varification box.....
Hello klaust...
I have three push buttons in haedware with the help of them i have to increase and decrease the value on timer sections as i shown in picture.
**broken link...
Hello,
I can't send complete(due to complexity) circuit but can explaine about it.
One thing,when i choose PIC16f722 in place of PIC16f72 i get same config word 0x3fb2 and get some output using pic16f72 controller.
Now i am able to control four 7 seg and 5 leds.
But now facing another...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
